Spot Adhesive Panels are supplied with resin-hardened spots on the back. A 2" diameter dab of construction adhesive is applied to the spot and the panel is applied to the wall. Temporary support is required to avoid slippage.	Perimeter Adhesive Does not require resin spots. A "picture frame" of adhesive is placed on the panel back about 3/4" from the panel edge. An "S" or "W" of adhesive is placed in the "frame". Temporary support is required to avoid slippage.	Z-Clips Special panel clips are mounted to the panel back at time of shipment. Corresponding wall clips or wall bars are installed on the wall at the appropriate location to allow attachment of the panel.
Concealed Splines A kerf is placed along the edges of the panel before shipment. During installation, the spline is inserted into the kerf of one panel and then mounted on the wall. An adjoining panel is then inserted onto the other half of the spline.	Impaling Clip/Adhesive Impaling clips are attached directly to the wall with the points extending outward. Adhesive is applied to the glass fiber panel, which is positioned and pressed into place onto the clips.	Hook & Loop Fasteners The loop portion of the fastener is applied to the panel at the time of shipment. The hook portion is attached to its mate, and when installing, the tape backing is removed and the panel is positioned on the wall. Permanent support is required.	Magnetic Fasteners Magnetic fasteners are affixed to the panel back before shipment to hold the panel on metal surfaces. Permanent support is required.
Square The most often used ceiling panel edge treatment, Square edge panels lie flat on the suspended grid.	Flush Reveal Designed specifically for the suspended grid shown below. Ceiling panel face fits flush with bottom of grid.	Standard Reveal For a more dramatic, dimensional look, the ceiling panel edges are revealed. Available for 9/16" or 15/16" grid systems.	Access™ System Patent-pending system permits ceiling panels to be easily pulled down for instant access to the space above.